Ambient temperature and humidity sensors

This system allows you to control the temperature in automatic mode or by manually adjusting the desired temperature for each room from the interface on a tablet or a computer.
For the convenience of heating control, you can configure heating scenarios. A heating scenario holds and stores statuses of the necessary air temperature settings. When the respective scenario is activated, parameters saved in the scenario are recorded in the operational ones. The T scenario is activated by a control command from the Interface or according to a selected timer.
If desired, a temperature and humidity sensor running on batteries according to an internal data transmission protocol can be used. In this case, wiring is optional.
Installation: The location of a temperature sensor wire should be at a distance of at least 2 m from doors and windows and at least 90 cm from the floor; if necessary, install it in a separate wall plate.
A thermoelectric servo 24-220V is installed on a circuit in the collector of underfloor heating. (Make sure to mark this servo according to the design.)
Functional check of the sensors is conducted by the temperature being detected; when the thermal sensor’s temperature exceeds 30 degrees, you will see the following message: “Warning: The thermal sensor exceeds the temperature range you have set up and is possibly damaged.”
The house heating will continue to work without ambient temperature stabilization.